blob: c6c6ccef0288c339419186e6bdffafc3f07b90d8 [file] [log] [blame]
# Copyright (C) 2014-2021 Free Software Foundation, Inc.
# This program is free software; you can redistribute it and/or modify
# it under the terms of the GNU General Public License as published by
# the Free Software Foundation; either version 3 of the License, or
# (at your option) any later version.
# This program is distributed in the hope that it will be useful,
# but WITHOUT ANY WARRANTY; without even the implied warranty of
# GNU General Public License for more details.
# You should have received a copy of the GNU General Public License
# along with this program. If not, see <>.
# On decr_pc_after_break targets, GDB used to adjust the PC
# incorrectly if a background single-step stopped somewhere where
# PC-$decr_pc had a breakpoint, and the thread was not the current
# thread, like:
# ADDR1 nop <-- breakpoint here
# ADDR2 jmp PC
# IOW, say thread A is stepping ADDR2's line in the background (an
# infinite loop), and the user switches focus to thread B. GDB's
# adjust_pc_after_break logic would confuse the single-step stop of
# thread A for a hit of the breakpoint at ADDR1, and thus adjust
# thread A's PC to point at ADDR1 when it should not: the thread had
# been single-stepped, not continued.
if {[prepare_for_testing "failed to prepare" $testfile $srcfile {debug pthreads}] == -1} {
return -1
if ![runto_main] {
# Make sure it's GDB's decr_pc logic that's being tested, not the
# target's.
gdb_test_no_output "set range-stepping off"
gdb_breakpoint [gdb_get_line_number "set breakpoint here"]
gdb_continue_to_breakpoint "run to nop breakpoint"
gdb_test "info threads" " 1 .*\\\* 2 .*" "info threads shows all threads"
gdb_test "next" "while.*" "next over nop"
gdb_test_no_output "next&" "next& over inf loop"
set test "switch to main thread"
gdb_test_multiple "thread 1" $test {
-re "Cannot execute this command while the target is running.*$gdb_prompt $" {
unsupported $test
# With remote targets, we can't send any other remote packet
# until the target stops. Switching thread wants to ask the
# remote side whether the thread is alive.
-re "Switching to thread 1.*\\(running\\)\r\n$gdb_prompt " {
# Prefer to match the prompt without an anchor. If there's a
# bug and output comes after the prompt immediately, it's
# faster to handle that in the following test, instead of
# waiting for a timeout here.
pass $test
# Wait a bit. Use gdb_expect instead of sleep so that any (bad) GDB
# output is visible in the log.
gdb_expect 4 {}
set test "no output while stepping"
gdb_test_multiple "" $test {
-timeout 1
timeout {
pass $test
-re "." {
# If we see any output, it's a failure. On the original bug,
# this would be a breakpoint hit.
fail $test