[gdb/testsuite] Add kfail in gdb.dwarf2/dwzbuildid.exp

When running test-case gdb.dwarf2/dwzbuildid.exp using target board readnow, I
get:
...
(gdb) file dwzbuildid-mismatch^M
Reading symbols from dwzbuildid-mismatch...^M
warning: File "dwzbuildid5.o" has a different build-id, file skipped^M
could not find '.gnu_debugaltlink' file for dwzbuildid-mismatch^M
(gdb) delete breakpoints^M
(gdb) info breakpoints^M
No breakpoints or watchpoints.^M
(gdb) break -qualified main^M
No symbol table is loaded.  Use the "file" command.^M
Make breakpoint pending on future shared library load? (y or [n]) n^M
(gdb) FAIL: gdb.dwarf2/dwzbuildid.exp: mismatch: gdb_breakpoint: set breakpoint at main
...

This is PR symtab/26797: when using readnow, a failure in reading the dwarf
results in the minimal symbols not being available.

Add a corresponding KFAIL.

Tested on x86_64-linux.

gdb/testsuite/gdb.dwarf2/dwzbuildid.exp

diff --git a/gdb/testsuite/gdb.dwarf2/dwzbuildid.exp b/gdb/testsuite/gdb.dwarf2/dwzbuildid.exp
index 721aef8..81cefc6 100644
--- a/gdb/testsuite/gdb.dwarf2/dwzbuildid.exp
+++ b/gdb/testsuite/gdb.dwarf2/dwzbuildid.exp
@@ -160,6 +160,13 @@
 
 	gdb_load ${binfile}-${testname}
 
+	if { $testname == "mismatch" && [readnow] } {
+	    # Main is found in the minimal symbols.  When using readnow, a
+	    # failure to read the dwarf also causes the minimal symbols to be
+	    # unavailable.
+	    # Setup a kfail for "FAIL: gdb_breakpoint: set breakpoint at main".
+	    setup_kfail "symtab/26797" *-*-*
+	}
 	if {[runto_main]} {
 	    if {$testname == "mismatch"} {
 		gdb_test "print the_int" \