Apply Tim walls octest vs bytes patch
diff --git a/bfd/section.c b/bfd/section.c
index e2ca443..c0bf60d 100644
--- a/bfd/section.c
+++ b/bfd/section.c
@@ -369,22 +369,25 @@
.
. bfd_vma lma;
.
-. {* The size of the section in bytes, as it will be output.
-. contains a value even if the section has no contents (e.g., the
-. size of <<.bss>>). This will be filled in after relocation *}
+. {* The size of the section in octets, as it will be output.
+. Contains a value even if the section has no contents (e.g., the
+. size of <<.bss>>). This will be filled in after relocation. *}
.
. bfd_size_type _cooked_size;
.
-. {* The original size on disk of the section, in bytes. Normally this
+. {* The original size on disk of the section, in octets. Normally this
. value is the same as the size, but if some relaxing has
. been done, then this value will be bigger. *}
.
. bfd_size_type _raw_size;
.
. {* If this section is going to be output, then this value is the
-. offset into the output section of the first byte in the input
-. section. E.g., if this was going to start at the 100th byte in
-. the output section, this value would be 100. *}
+. offset in *bytes* into the output section of the first byte in the
+. input section (byte ==> smallest addressable unit on the
+. target). In most cases, if this was going to start at the
+. 100th octet (8-bit quantity) in the output section, this value
+. would be 100. However, if the target byte size is 16 bits
+. (bfd_octets_per_byte is "2"), this value would be 50. *}
.
. bfd_vma output_offset;
.
@@ -920,7 +923,7 @@
Sets the contents of the section @var{section} in BFD
@var{abfd} to the data starting in memory at @var{data}. The
data is written to the output section starting at offset
- @var{offset} for @var{count} bytes.
+ @var{offset} for @var{count} octets.
