blob: 5aea60a526b3fc0ab52fe92679e12feb62f4904f [file] [log] [blame]
# This testcase is part of GDB, the GNU debugger.
# Copyright 2019-2021 Free Software Foundation, Inc.
# This program is free software; you can redistribute it and/or modify
# it under the terms of the GNU General Public License as published by
# the Free Software Foundation; either version 3 of the License, or
# (at your option) any later version.
# This program is distributed in the hope that it will be useful,
# but WITHOUT ANY WARRANTY; without even the implied warranty of
# GNU General Public License for more details.
# You should have received a copy of the GNU General Public License
# along with this program. If not, see <>.
# Test that GDB can correctly read the binary and shared libraries
# with different sysroot setups: local and "target:".
load_lib gdbserver-support.exp
if { [skip_gdbserver_tests] } {
verbose "skipping gdbserver tests"
return -1
if {[build_executable "failed to prepare" $testfile $srcfile "additional_flags=--no-builtin"] == -1} {
return -1
# Run once with sysroot set to the local filesystem and once set to the remote
# target.
foreach_with_prefix sysroot { "local" "remote" } {
global srcdir
global subdir
global binfile
if { $sysroot == "local" } {
set sysroot_command "/"
set reading_symbols "Reading symbols from $binfile..."
set timeout_factor 1
} else {
set sysroot_command "target:"
set reading_symbols "Reading $binfile from remote target..."
set timeout_factor 5
# Reading debug info from the remote target can take a bit of time, so
# increase the timeout in that case.
with_timeout_factor $timeout_factor {
# Restart GDB.
# Make sure we're disconnected, in case we're testing with an
# extended-remote board, therefore already connected.
gdb_test "disconnect" ".*"
# Start GDBserver.
set res [gdbserver_start "" $binfile]
set gdbserver_protocol [lindex $res 0]
set gdbserver_gdbport [lindex $res 1]
# Set the sysroot.
gdb_test_no_output "set sysroot $sysroot_command"
# Connect to gdbserver, making sure GDB reads in the binary correctly.
set test "connect to remote and read binary"
if {[gdb_target_cmd $gdbserver_protocol $gdbserver_gdbport $reading_symbols] == 0} {
pass $test
} else {
fail $test
gdb_breakpoint main
gdb_test "continue" "Breakpoint $decimal.* main.*" "continue to main"
# Test that we can stop inside a library.
gdb_breakpoint printf
gdb_test "continue" "Breakpoint $decimal.* (__)?printf .*" \
"continue to printf"